What Forma's Indoor Daylight public beta opened up
On November 4, 2026, Autodesk announced that Indoor Daylight was in public beta for all Forma Building Design users. In either the 3D view or floor plan, a user can select Indoor Daylight in the analysis panel and start the analysis automatically. Autodesk describes the result as a view of natural light access during occupied hours over a typical year. The release post includes an illustrative floor-plan map. It shows the kind of output available at launch, while the accompanying description establishes the access change for Building Design users. Autodesk's November 4 announcement
What does the evidence show?
Glazing in the tower study
Design inputs. The filled segment represents glazing area.
Less daylight on the east side
Architect Jessica Carson reported visibly less daylight access along the east façade after reducing the glazing ratio from 50% to 20%. This was a visual comparison in one modeled study.
Autodesk announced public beta access for Forma Building Design users after the conference study.
Release announcementIndoor Daylight joins sun hours and the daylight potential analysis for façades and windows. Autodesk describes the façade tool in terms of daylight available at exterior surfaces. A Building Design floor-plan analysis lets a designer ask a different question about the space behind the glass. The distinction matters when an exterior analysis identifies a shaded façade and the design team still needs to place habitable rooms, circulation and other uses within a floor plate. An Autodesk Community thread from May and June documents the earlier prototype and closed-beta access. The November announcement broadened access to the interior tool. Autodesk's Indoor Daylight description · Autodesk's façade analysis documentation · Earlier Community discussion
Comparing glazing on shaded tower floors
In a GHD Design and Autodesk session at Autodesk University in September, architect Jessica Carson explained how she used Indoor Daylight on a residential tower study. She converted a Site Design model to Building Design and first ran an outdoor daylight analysis across the building. She focused on the tower's first two levels after the exterior pass flagged overshadowing there. The first interior run applied a 50% window-to-wall ratio to the relevant floors. Carson used that option as a comparison point. The indoor map gave the team an indication of where habitable rooms and glazing could go in a constrained urban floor plate. Autodesk University class AS1983 · Indexed class transcript
Carson reduced the ratio to 20% and ran Indoor Daylight again. She reported that access fell visibly along the east façade. A separate Carbon Insights comparison gave her a way to weigh that daylight loss against the operational carbon change. After laying out the units in more detail, she reran Indoor Daylight and still found the eastern units potentially problematic. That sequence shows how a first pass can guide where to draw rooms and a later pass can check whether the layout addresses the areas of concern. The available account records a qualitative change on the map. It gives no reproducible room-by-room lux table or basis for a compliance conclusion. Class transcript on the glazing scenarios and unit layout
What the two dates establish
Autodesk lists the study in its September 15–17 conference program, before the November 4 release. The presentation documents an architect comparing modeled alternatives and using the output to investigate a specific part of a floor plan. The release announcement establishes when all Forma Building Design users could access the public beta. The November 5 BIMdigest recap reports that availability and summarizes the launch illustration. A signed-out Reddit search from October 28 through the November 18 cutoff found no dated submission about Indoor Daylight in public beta. The public search did not verify a practitioner rerun after November 4, so the conference study supplies the observed workflow and its documented limits. Autodesk's conference guide · November 4 announcement · November 5 BIMdigest recap