AI&Design
All change articles

Autodesk Forma · Announcement · Official source

Planning vertical circulation with native stairs in Forma

Autodesk’s July 13, 2026 update documented native stair placement and editing in Forma Building Design. A stair can span multiple floors within one building, and Forma adjusts its riser count as floor heights change. Designers can resize stairs with handles, read the flights in plan, and see the stairs in 3D and section. The feature lets teams account for the space a stair and its core occupy while they are still comparing schematic layouts. Autodesk’s July update · Autodesk Community clarification

Placing and reviewing a stair

On July 6, Autodesk Solutions Engineer Olivier Bayle illustrated placing a standard stair against walls in plan, reshaping it with handles, setting its start and end floors and width, and reversing the direction of ascent. The perspective view showed the stair and the floor openings that Forma generated. The demonstration documents the workflow a week before the July 13 roundup, which remains the release record date. Autodesk also says stairs carry into the Revit export, where teams can continue detailed model development. Bayle’s stair example ends in Forma. Village BIM walkthrough · Village BIM editorial team · Autodesk’s July update

Where the stair tool stops

On July 17, an Autodesk Community participant described a taller ground floor modeled as a separate Forma building. They wanted a continuous stair to the upper building and a ground-floor exit on the opposite side from where people entered on upper floors. Autodesk’s community manager confirmed that each stair belongs to one building and keeps the same flight orientation across the floors it serves. The reply suggested modeling separate runs and allowing layout space for the ground-floor route. The same issue can arise when physically connected parts of a design are represented by separate building objects. July 17 report · July 20 accepted response

Forma flags stairs that cross a floor footprint or overlap a wall, elevator, or another stair on any floor served. Autodesk’s reply describes these as geometry checks and says the tool leaves minimum stair and landing sizing to the designer. In September, another participant requested separate control of landing width after raising concerns about clearances near doors and an area of refuge. These reports show where a schematic stair can help reserve space and where the designer still has to resolve circulation and assess applicable egress and accessibility requirements during detailed design. Autodesk’s July update · July 20 accepted response · September 29 feature request

A signed-out search for original Reddit posts or comments from July 6 through July 27 found no dated result about placing or editing stairs in Forma Building Design. Native Reddit search was inaccessible in the public reader, so this is a bounded result from indexed sources.